baby pacifier clip manufacture.The Solution to Bad Silicone Facial Cleansing Brushes!

　　Silicone cleaning brushes have long become a common item in daily necessities. The main reason why cleaning brushes can be favored by consumers is its design. From nylon fibers to silicone, the audience has always been on its face. What are the main factors? Many silicone product manufacturers know that the cleansing brush head is the most important thing in the product. It is different from the fiber brush in that each brush head is formed by a finishing mold and obtained by high temperature vulcanization. The entire facial brush has the characteristics of strong toughness and soft rebound, so it is inevitable that some bad phenomena will occur in the production process.

　　In the production process, because the brush heads on the entire face are denser, and there is a suction cup on the back of the product, the method of mold design is also more difficult. Only the middle plate of the mold can be designed as the mold core to be demolded on the top of the mold core, and each product needs to be pulled by hand to be demolded, so it is inevitable that the brush head on the face and the suction cup at the bottom will be damaged. It is because the diameter of the brush head is less than 0.8mm and less than 1mm, and the distance between the brushes is too narrow, so the brush head will be wrapped and broken during production, so some reasonable methods need to be used to solve it during production.

　　In many cases, the reasons for the defects also have different requirements in terms of skills. Therefore, when it is easy to be pulled off when pulling, the staff should pay attention to using appropriate strength. Since the core of the silicone cleaning brush shuttles in the middle of the cleaning brush, it is forced to pull. It will cause the base of the product to be broken. Secondly, try to slow down the speed of the mold when ejecting the mold. Do not let the brush head break in the mold. Because the brush head is too thin and broken, it is impossible to see whether it breaks with the naked eye, and it is ignored. Under the circumstance that there are often several hours or even a day of bad phenomena in a row, it is necessary to carefully check whether the brush heads are complete after the mold is released. For the brush head air wrapping phenomenon, as long as it is within a certain temperature and time, it will basically not occur, but the speed of operation after mold release is too slow, and the air wrapping phenomenon will easily occur.

Read recommendations:

The premise of high-quality silicone products, have you selected the mold steel?silicone pacifier cl

Rabbit teether

Octopus Captain Teether

pacifier bibs manufacturer

baby pacifier mask Production