Quick Trimming Method for Small Silicone Products!baby cup silicone custom

　　Burr trimming is an indispensable process in the silicone product industry. After the molding production is completed, some products will retain a large amount of burr rubber on the self-demolition line. Some large products can easily remove the burr from the self-demolition. However, there are Even if some small products are made to the extreme on the mold clamping line, there is no difficulty in removing the edge, but in the face of a large amount, tens of millions of quantities need to be manually removed, and the labor consumed is enough. I don't know how much time it will take!

　　Sometimes some small sealing rings, small sealing parts and other products are too small in size, especially for some products with many holes, the whole piece of products needs to be trimmed mechanically. Grinding, punching, round knife edge tearing, etc., are mainly used for fine burrs and batch processing, so that the burrs on the self-removing line can quickly fall off. It is the most effective method for small products and a large number of them.

　　The hardness suitable for mechanical trimming is about 30-60 degrees. If it is too hard, it may cause product breakage at any time if it is not adjusted properly when mechanically adjusting the size. Therefore, usually do not put high-hardness products in reproduction, and there is a A bad problem, because the machine adjusts the size of the machine according to the size of your product, so it is very important to adjust the size. If the size error is too large, the burrs of the product may not be removed, and if it is too small, the product may be broken. , so it is feasible to use a few products to try it out when using the edger.

Read recommendations:

Do pacifiers make bloating worse?newborn baby pacifier direct sales

Snortseling mask SC

Silicone watch blets

baby fruit nipple wholesale

baby pacifier feeder custom