baby pacifier clips Manufacturing.Conflict between silicone products and rubber products

　　A few days ago, an engineer from a silicone product factory visited our factory and mentioned that the production of a product could not achieve good results during the vulcanization process. During the vulcanization process, raw materials with a hardness of 35 degrees and a low-temperature vulcanizing agent were required. The product has poor tensile strength and the product is too brittle. He said that after repeatedly adjusting the room temperature, color, and temperature and time, the adjustment still fails, but the specific reason cannot be found. At this time, the old engineer of our company heard and asked if it was produced together with rubber. He heard that after hearing it, he said, is there a conflict between the production of silicone and rubber? ! !

　　According to this statement, I asked about the vulcanizing agent again, only to realize that it is likely to conflict with the vulcanizing agent. In fact, many colleagues do not know that when the silicone raw material is produced with a low-temperature vulcanizing agent and a low-temperature vulcanizing agent for rubber materials, air will be generated. Chemical reaction, silica gel and rubber colleagues use low-temperature vulcanizing agent to make a large number of molecules form intersecting substances during the addition process. Silica gel and rubber are made of different chemical substances, and the toxic substances in rubber will form molecular reactions in the air, and silica gel will adsorb Because of the difference in the synthesis method of rubber chemical molecules, the processing properties of silica gel and rubber have changed. Silica does not have any conflict with styrene and butadiene. In this way, styrene and butadiene can reach a certain level at room temperature at low temperature vulcanizing agents. After the temperature, it will emit toxic substances and affect the silicone products. There are mainly air bubbles, unfamiliar processing, insufficient stretching and so on.

　　Therefore, when using low-temperature vulcanizing agent in production, try to make the environment room temperature suitable for production. The production of low-temperature vulcanizing agent must not contain copolymers such as styrene, which is easy to volatilize in the air and generate silica gel, which will lead to immaturity of silica gel products, such as incorrect formula, temperature If it is out of balance, it will cause the loss of material properties and the release of various chemical substances, resulting in the aging and deformation of the low-temperature vulcanizing agent molding products, and the appearance of various undesirable phenomena such as color temperature differences.

Read recommendations:

Reminder again: prevent environmental protection policies in advance, you can save a lot of things!s

Silicone anti-eating finger cots

Silicone flower teether

animal pacifier clip

baby gags on pacifier Vendor